VPI HW-19 MK-4 Manuel d'instructions

1 HW-19 MK-4 SETUP MANUAL

10 THE HW-19 MK-4 TURNTABLE SETUP AND INSTRUCTION MANUAL VPI INDUSTRIES INC., 77 CLIFFWOOD AVE #3B, CLIFFWOOD, NJ 07721 PHONE

2 PRELIMINARY REMARKS  Save the carton and all internal fillers and plastic bags. If you should ever need to carry or ship the HW-19 Mk. 4 any di

3 2. ASSEMBLING THE HW-19 MK-4 YOUR CHASSIS HAS AN ACRYLIC MOTOR BOARD, DO NOT PEEL OFF THE PROTECTIVE PAPER COVERING UNTIL DIRECTED.  While the

4 3. MOUNTING THE TONEARM  If you have a blank (without armhole) mounting board: NOTE: DO NOT peel off the protective paper from acrylic boards u

5 3/16” ARMBOARD WOOD FRAME SPRINGS 4. LEVELING THE HW-19 MK-4  The MK-4’s on/o

6 5. FINAL ASSEMBLY  Place the dustcover on the MK-4 by slipping the hinge flanges into the sockets on the rear of the base. Close the cover. E

7 platter. You will notice that over tightening will sometimes result in the periphery lifting off again. Do not over tighten.  After usi

8 of the MK-4 chassis. Connect the other end to the ground connector on the amplifier or receiver (if in doubt, check the amplifier or rece

9  The MK-4’s dust cover and acrylic chassis may be cleaned with glass cleaner. Do not use solvents, abrasives, or other glass cleaners of any so