VPI Scoutmaster JMW-9T Manuel d'instructions télécharger pdf (Page 8)

turn the adjustment wheel above the base. When the arm is at the desired

height, tighten the screws.

• If you do not raise the arm when doing this you will be between .2 to .4

grams light when you are on the record. THIS IS VERY IMPORTANT!!

• Follow the gauge instructions and set the tracking force according to the

cartridge manufacturer’s recommendation. We recommend always going to

the high side of tracking force. High frequency vibrations on a light-tracking

cartridge can cause more damage to the grooves of a record than running a

cartridge at a heavy setting.

• Put a record on the platter and lower the arm so it is parallel to the record.

Now you will be tracking at the force you set and not a lighter force.

Setting the Azimuth

• Set a fireplace match or coffee stirrer (something light and about 6” long)

into the groove behind the mounting screws on the tonearm headshell.

• If it is not level, use the supplied Allen wrench to loosen the setscrew on

the counterweight and rotate the counterweight around the shaft until the

headshell is parallel to the record. Be careful not to change the tracking

force setting.

• If you prefer you can rotate the azimuth ring to set azimuth instead of

rotating the counterweight.

AZIMUTH RING

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

VPI Scoutmaster JMW-9T Manuel d'instructions Page 8