VPI Classic 3 Manuel d'instructions télécharger pdf (Page 3)

Unpacking the Box

The turntable and tonearm are packed very carefully to avoid damage during

shipping. It is important that you save the packing materials and box to use for

shipping or moving the Classic.

• Set aside the bag containing the drive belt.

Complete and return the warranty card. The

warranty does not take effect until the

warranty card is returned.

• Remove and set aside the following items:

Alignment Jig.

Record clamp.

Power cord.

Bag containing screwdrivers and screws for mounting the cartridge.

Shure Stylus Force Gauge

JMW-Classic tonearm wand

• Remove the large foam top packaging piece and place it on the side.

• Make room for the turntable, it will be ready to place in its final

destination immediately.

• Grab the turntable on the sides where the foam is cut out and lift straight up.

Be careful, the turntable is very heavy (48 pounds) if you need help, get it.

Place the turntable on a flat sturdy surface that will support the weight.

• Carefully slide the plastic bag off the turntable.

• Lift the aluminum turntable platter off the bearing and remove the round piece

of foam below it. Be very careful not to hit or damage the motor pulley. It

measured +/- .0005” when it was tested at the factory. Try not to disturb it at

all. The platter can be damaged if it is hit, be careful.

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

VPI Classic 3 Manuel d'instructions Page 3