VPI HW-19 MK-4 Manuel d'utilisateur

1 PRELIMINARY REMARKS  Save the carton and all internal fillers and plastic bags. If you should ever need to carry or ship the HW-19 Mk. 11

2 1.9 The last item in the carton is the turntable platter. Leave it in place until it is needed later. 2. ASSEMBLING THE HW-19 MK-3 YOU

3 tighten the clamp, it will press the platter evenly onto the spindle, seating it fully. Make the clamp very tight but don’t overdo it. Leave the

4 3.6 Fasten the arm board to the chassis with the six screws. Make sure that there is a washer under each screw head. Tighten each screw well. 3.

5 However, if you do want to be a fanatic, put a bubble level on the platter. Center the bubble by rotating the base’s rubber feet to raise

6 7.6 Finally, take the knurled clamp and screw it down (flat side down) over the puck. Tighten it enough that the periphery of the record is broug

7 cartridge/arm/turntable problem. Usually all that is needed to eliminate the hum is to run a ground wire from the turntable chassis to the chassis

8 an extremely thin layer, degrading electrical contacts. Once a contact has been contaminated with silicone, it is nearly impossible to clean it co